Security-9 Milling and test fire

General Discussion Section for All Makes and Models of Handguns and Rifles, including Aftermarket Accessories.
Post Reply
GallowayPrecision
Member
Posts: 28
Joined: Thu Sep 06, 2018 3:42 pm
Location: Fletcher, NC
x 3
x 15
Contact:

Security-9 Milling and test fire

Post by GallowayPrecision » Thu Nov 08, 2018 11:24 am

We finally got the chance to mill the Security-9 for an optic. Came out really nicely.


Image Image
1 x

GallowayPrecision
Member
Posts: 28
Joined: Thu Sep 06, 2018 3:42 pm
Location: Fletcher, NC
x 3
x 15
Contact:

Re: Security-9 Milling and test fire

Post by GallowayPrecision » Thu Nov 08, 2018 11:25 am

[media][media]
1 x

User avatar
Janik
Staff Member
Posts: 640
Joined: Mon Apr 23, 2018 5:59 pm
Founding Member #: 001
Location: Iowa
x 723
x 273
Contact:

Re: Security-9 Milling and test fire

Post by Janik » Sun Nov 11, 2018 12:41 am

That's cool. Are you milling Canik slides for optics, such as the SFL, SF, etc? I'd like to have the slide milled on my SFL and keep the rear iron sight. I'm also looking to have a slide milled for a CZ P09. I know there's a couple companies out there that do CZ, but not familiar if anyone is doing it for Caniks.
0 x

GallowayPrecision
Member
Posts: 28
Joined: Thu Sep 06, 2018 3:42 pm
Location: Fletcher, NC
x 3
x 15
Contact:

Re: Security-9 Milling and test fire

Post by GallowayPrecision » Mon Nov 12, 2018 10:40 am

Janik wrote:
Sun Nov 11, 2018 12:41 am
That's cool. Are you milling Canik slides for optics, such as the SFL, SF, etc? I'd like to have the slide milled on my SFL and keep the rear iron sight. I'm also looking to have a slide milled for a CZ P09. I know there's a couple companies out there that do CZ, but not familiar if anyone is doing it for Caniks.
We are, sending our Elite over to our machine shop today for a Trijicon RMR. We can do the P09 as well.
1 x

User avatar
FrankW
Member
Posts: 81
Joined: Mon Jun 04, 2018 9:49 am
Founding Member #: 013
Location: Central Florida
x 3
x 33

Re: Security-9 Milling and test fire

Post by FrankW » Mon Nov 12, 2018 11:24 am

Hi GallowayPrecision,

Have you seen this thread about milling the Canik slide for a RMR. viewtopic.php?f=9&t=654

Frank
0 x

Post Reply